
One-Piece Front |
These are the typical stovepipe civilian boot, cut straight across the top (flat top). The shorter (10" mid-calf) boot is designed to be
wore under the pants, while the taller (16" to 18" just below the knee) boot is usually worn outside the pants; although any of them can be worn inside
or outside. This is an excellent boot for a Civilian or Confederate impression. These boots come with Sewn On Soles.
They come with options for the color, toe style, heel style, height, pull type and heel plates.
Color: black or russet smooth out leather.
Top Height: 10 inch, 12 inch, 14 inch, 16 inch, 17 1/2 inch, 18 inch, 19 inch or 20 inch; as measured from the top of the sole or in
bare feet from the floor to the height wanted (i.e. does not include heel height and sole thickness). Height is approximate and will have some variation from
listed height (plus or minus 1/2").
CAUTION heights over 17 1/2 inches MAY come up higher than the bend of your knee, restricting movement. Be sure your order a
boot height that come up NO HIGHER than the bend of your knee. Also if you have large calves, larger than 16", put your calf size in the notes field
on the page where your billing and shipping address go.
| Top Style: All boots have the body of the boot
(the part over the foot) made from two pieces. |
1 Piece Front: Entire front of the boot is a single piece of leather, stretched to form
front of boot. Three pieces (not including the sole). |
1 Piece Top: This is where the top of the boot is one piece with no welt. This boot also is made up of
three pieces (not including the sole). Recommended for 10" & 12" Only. |
2 Piece Top: This is the way modern boots are made, where there are four pieces,
two for the top and two for the body (not including the sole). |
Toe Styles: Square Toe (Shown) or Rounded Toe.
Heel Styles: Walking Heel (most common), Cuban Heel (similar to modern cowboy boot heel) or Modern Cowboy Heel.
Pull Styles: Outside Pulls (Shown on upper left picture), Inside Pulls (don't show outside) or Mule Ears.
Heel Plates: None, Supplied Loose with boots or Installed on boots.
Measurements Needed.
Please use a cloth tape for these measurements. Measure over socks / pants material as appropriate. |
 |
1 |
Ball |
Measure around the ball of the foot. (circumference) |
| 2 |
Instep |
Measure around the instep. (circumference) |
| 3 |
Heel to Instep |
Measure from the heel around the instep and back to where
you started. (circumference) |
| 4 |
Ankle |
Measure around the ankle. (circumference) |
| 5 |
Calf Size
(Largest) |
This is the measurement of your calf at the largest point. IF you will be wearing the pants inside the boots then take this measurement outside the
pants, with the pants on, that you are going to wear. (circumference) |
| 6 |
Boot Top
Circumference |
Measure around the leg at the point where the top of the boot will
come. (circumference) |
| 7 |
Calf Height |
The height from the floor where measurement 5 (calf size) was taken. |
| 8 |
Boot Top
Height |
Height from the floor to where the top of the boot will come. |
| 9 |
Instep to
Tip of
Big Toe |
Measure from the instep to the end of the big toe. |
Made-To-Order item, please allow 4 -
14 weeks for delivery. Made-to-Order items are not returnable, unless they are not made as
ordered. Starting price is for material and style shown, other materials or
other changes will affect the price. NO Rush orders are available. |